Olight M3X Triton

The high-end Olight M3X Triton tactical flashlight delivers extreme light output of up to 700 ANSI lumens. The performance has been achieved using Cree Xlamp XML LEDs. The flashlight can operate in 2 light modes and one flashing mode, with up to 15 hours of run time, while the electronics maintain constant light brightness as long as possible. Power options: 18650 batteries, or 3-4 CR123 lithium cells, It is not recommended to use RCR 123 batteries as they may not provide enough power for turbo mode. Olight M3X Triton Flashlight Parameters: Uses the highest efficiency Cree Xlamp XML diode currently available.700 ANSI lumens (1.2 hours) 60 ANSI lumens (15 hours) - Strobe 10 Hz (2.4 hours)Power supply 3x lithium CR123 batteryWhen using the supplied battery extender, 4x lithium CR123 batteries or 2x li-ion18650 batteries can also be usedDigital control to maintain constant brightness while discharging the batteries. Smooth parabolic reflector for extreme range. Steel clip for belt attachment. Body finish allows for a firm gripMade of aerospace grade duralumin with a durable Hard Anodized III finish. Hardened ultra clear glass. Mode switching by loosening or tightening the lamp headWaterproof to IPX-8 standard. Dimensions: 21.1 cm (length), 6.3 cm (head diameter), 2.5 cm (body diameter). Length with battery extension: 24.5cm. Weight: 266 grams. The flashlight comes with a wide range of accessories: carrying case, battery extension, belt clip and 3xCR123 battery tray.

Control: for signal or momentary switching on, press the button on the end of the flashlight, for permanent switching on, press the button until full click. Repeated loosening/tightening of the lamp head toggles between power modes. The luminaire remembers the last set mode. Note: If the protective rubber rings appear damaged after prolonged use, replace them. The rings should also be lubricated to prevent erosion of the rubber. If the lantern flickers or does not light up, it may be caused by: Batteries are almost dead - replace them. Contacts inside the lantern are clogged - clean them with a cloth dipped in alcohol. The head, body or back of the lamp is loose - add lubricant to the sealing rings and tighten the head and end of the lamp firmly. Insert the batteries with the positive terminal towards the head of the lamp,to avoid damaging the lamp. The lamp has a high light output. When lighting, do not look into the reflector and take care not to shine the light directly into the eyes of others.